Electrical power UNITS FOR LIFT TABLE 1
Common Description
This energy unit is designed solely to the small lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit is broadly utilised inside the field of logistic gadgets like minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed from the solenoid valve with all the speed managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This energy unit is built exclusively for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as the speed controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power supply is reduce, the reducing movement is managed by the manual override function.
Power UNITS FOR LIFT TABLE three
Standard Description
This electrical power unit is made solely for that large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve plus the pace controlled by a pressure compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This power unit is built exclusively to the substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve along with the speed managed through the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is reduce, the lowering motion is controlled from the guide override function.
Exclusive Notes
1. This power unit is of S3 duty cycle, which may only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned ahead of installation of the energy unit.
three. Viscosity of your oil shoud be 15~46 cst,which really should also be clean and totally free of impurities.N46 hydraulic oil is suggested.
4. Oil changing is required just after the initial 100 operation hrs,afterwards once every 3000 hours.
5. The power unit shown is created to be mounted vertically.