rotary cutter gearbox
rotary cutter gearbox
RC-20 Sequence
Specs
Torque: one,750 – 3,267 lb.-in.
198 – 369 Nm.
Ratios: one:two.five, 1:two.eighty three
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 16 oz. (.forty seven L)
Fat: 34 lbs. (15.4 kg)
Applications
Finishing Mowers Rotary Cutters
Rotary Slashers Toppers
RC-27 Collection
RC-thirty Series
Requirements
Torque: 2,800 – four,667 lb.-in.
316 – 527 Nm.
Ratios: 1:1.forty seven, one:1.71, one:one.93
Seals: Triple Lip Spring Loaded
Bearings: Deep Groove Ball
Oil Cap: 23 oz. (.sixty eight L)
Fat: 51 lbs. (23.1 kg)
Applications
Ending Mowers Rotary Cutters
Rotary Slashers Toppers
RC-fifty one Collection
Specifications
Torque: 2,800 – four,667 lb.-in.
316 – 527 Nm.
Ratios: 1:one.47, one:one.71, 1:1.ninety three
Seals: Triple Lip Spring Loaded
Bearings: Tapered Roller/ Deep Groove Ball
Oil 
Cap: 27 oz. (.eighty L)
Bodyweight: fifty six lbs. (twenty five.four kg)
Programs
Rotary Cutters Rotary Slashers
Gears: Obtainable with either straight bevel or spiral bevel gearing.
Electrical power: Hp & Torque primarily based on AGMA method for constant responsibility additionally a service or load course aspect.
Shafting: A variety of dimensional, metallurgical, and warmth-handle options offered.
Bearings: Geardrives obtainable with a variety of bearing life possibilities.
Lubrication: Drives offered with different lubes based on functioning characteristics
Replacement Rotary Cutter gearbox, 40hp rated, 1-three/8″-six spline input shaft, 1.fifty seven” X 12 tapered spline output shaft and 1:1.47 velocity up ratio. These gearboxes have a sq. housing configuration and are equivalent in mounting and ratio to the round configuration gearboxes. These are unique tools gearboxes on the IM402, IM502 and IM602 collection rotary cutters which featured slip clutch PTO shafts. This gearbox will not fit the IM400, IM500 and IM60 types as they have a easy enter shaft! If your gearbox has a twelve spline output shaft and a 1-three/eight” – 6 spline enter shaft this gearbox will operate. Bolt pattern is 4-three/4″ on centre gap to hole and six-three/4″ heart to center of bolt gap on diagonal. The mounting holes sort a square bolt sample.
rotary cutter gearbox
Visit our site for more articles similar to this concerning rotary cutter gearbox.